0
Answered

The remote location of current transformers

Виталий 5 years ago in Equipment updated 5 years ago 3

Question 1. Is it possible to connect a CT, for example for D103, from the device itself at a distance of about 10 m? This is due to the location of the electrical panel and access to the input line. If so, what cable is necessary?

Question 2. Is it possible that two CTs work in parallel on one phase with one device of type D103 (for example, the same phase is divided into two lines and you need to know the amount of electricity consumption from both)
Thanks.

Image 305

GOOD, I'M SATISFIED
Satisfaction mark by Виталий 5 years ago
Answered

1. Такую длину не проверяли. Максимальная длина у нас 1 м. Но в принципе, для переменного тока и хорошего провода можно пробовать. Проверьте в тестовом режиме, подключите на один и тот же провод кольцо на родном проводе и на 10 метровом, и проверьте данные. Если показания Вас устраивают, то все в пориядке. )

2. Паралельно трансформаторные кольца подключить не получится. Устройство откалибровано под конкретное кольцо.

1. This length of wires was not checked. The maximum length we have is 1 m. But in principle, for alternating current and good wires can be tried. Check it in a test mode, connect the CTs on the native wire and 10 meters wire, and check the data. If you are satisfied with the accuracy, then everything is in order. :)

2. Parallel connection of CTs cannot be connected. The device is calibrated for a specific CT.

Виталий, Вам удалось вынести ТТ,? проблема с расположением в щитовой, нужно удлинить провода примерно метра на 3.

...Не удалось до сих пор проверить, к сожалению. Заминка на объекте возникла.