Connecting to a wireless network

For normal operation of the device, it is necessary, in the place of its installation, to ensure the presence of a signal from your wireless network.

When you first start or after restoring the factory settings, the device enters the wireless access point mode.


To connect to your wireless network, follow these steps:

  1. On your computer or phone, go to the list of wireless networks and select the connection to the “smart-MAC” + network (your device number). In case the “smart-MAC” + network (your device number) is missing, press the Reset button on your device. The default connection password is missing.
  2. After successful connection, enter http://192.168.4.1 in the address bar of your browser and go to the device’s built-in WEB site.
    The default login password is 0000
  3. In the “WiFi and Network” section, select the name (SSID) of your network from the list of wireless networks, click the “Connect” button and enter the password of your network. If there is no name (SSID) of your network in the list of wireless networks, update the list by clicking the Refresh button.
  4. Update the connection status or reload the page and make sure that the connection is successful and there is an internal IP address of the device in the status bar. In case of a connection error, repeat step 3.
  5. Go to the built-in WEB site of the device using the IP address obtained when connecting and continue setting the parameters.

To complete the installation and connection of the device, configure the settings using the following steps:

  1. In the «Configuration» section,select the WEB interface language that is convenient for you.
  2. Change the password to access the device’s WEB interface. 
    The default password 0000 will not allow you to connect devices to your account on the “cloud server”. 

    The password should consist of numbers and have a length of no more than 10.
    Your new password will allow you to access data from your device stored on the “cloud server”.
  3. In the «Data» section you can set the initial values of cumulative counters.
  4. In the «Data Server» section, check the device connection to the «cloud» server.
  5. In the «Status» section, view and copy the device ID for yourself. You will need the device ID to connect the device to the «cloud server».

WARNING:
Remember your new password to access the device’s WEB interface. No password recovery mechanism. If you have forgotten your password, to restore access to the device and data, perform the procedure of restoring the factory settings.


If you have difficulty finding a device on your network, use the search utility.  Download »

This article was helpful for 4 people. Is this article helpful for you?